| |
- Inquiry of Extruder
We are urgently looking for an extruder for rubber material extruding. The specifications and requirements are listed as follows:
1.Extrusion output: less than 500g/batch
2.For the extrusion of cylindrical strips with diameter of D = 1.0~7.5mm, with tolerance of ±0.05mm
3.Heating / Cooling device (2 zones: 1 zone extruder barrel, 1 zone extruder screw)
4.AC motor speed to be adjustable via control panel (please advise adjustment range)
5.Extrusion left over should be less than 200g.
6.Output to be approximately 700-1000g/hr
7.Extrusion head, screw, and tube must be able to be easily installed, dismounted and cleaned.
8.Corrosion/rust resistant material to be used in the construction of the extruder.
9.The extruder must be able to operate on materials with hardness up to 80 Shore A.
If your products meet our inquiry or you need further information, please feel free to contact us.
Contact person:
Ariel L. Y. Chen
TEL : 886-2-22988556 ext.146
FAX : 886-2-22983850
E-mail: ariel@mail.mfc.com.tw
|
